Fittings

Home > fittings > Schedule 5-10-40 Pipe to Tube Fittings

Schedule 5-10-40 Pipe to Tube Fittings

Schedule 5-10-40 Pipe to Tube Fittings Schedule 5-10-40 Pipe to Tube Fittings

PRODUCT CATALOG

Schedule 5-10-40 Pipe to Tube Fittings Catalog

PRODUCT SPECIFICATIONS

Schedule 5, 10, 40 Pipe to Tube Fittings Specifications

Alloy: T304 or T316L

Sizes: 1/2" OD  --  12" OD

Finish: Polish ID/OD

Schedule 5-10-40 Pipe to Tube Fittings

Sanitary Solutions is your source for T304 or T316L Schedule 5-10-40 Pipe to Tube Fittings found primarily  in the Battery, Beverage, Water Filtration, and Paint Industries. Our Schedule 5-10-40 Pipe to Tube Fittings meet or exceed 3-A standards with an ID polish or 180 Grit or 25 Ra on the Inside of the Tube and a 150 Grit or 32 Ra on the Outside of the tube.  Sanitary Solutions caps and bags each clamp fitting, marks each product with the size and alloy and a heat number for full trace ability for either alloy. Our Schedule 5-10-40 Pipe to Tube Fittings are made to close tolerances to permit easy and fast installation of a corrosion resistant, crevice free, fully sanitary process line.

When placing an order that day, our sales staff  will send you an e-mail confirmation and tracking information showing that the product  shipped the day of the order and that the product shipped complete. Take a few moments to browse the PDF Schedule 5, 10, 40 Pipe to Tube Fittings Products that we stock from 1" -- 6"  or can have made to fill your requirements and upon review, we think you will agree that the dimensions shown in this PDF are to standards accepted by the industry and meet your line space requirements when retrofitting or replacing.

As a rule of thumb to distinguish between pipe and tube-- You can take a piece of tube and slide into a piece of pipe-- But, you can't take a piece of pipe and slide it into tube because the OD of pipe stays the same but, depending on wall thickness, the ID will vary.

Upon downloading the Schedule 5, 10, 40 Pipe to Tube Fittings in PDF, please refer to the "NEW 2015 SANITARY SOLUTIONS CATALOG.

Material Test Reports -- Click here for the  Material Test Reports page and put in your heat number to receive a PDF copy of your report --- now that's simple!

Sanitary Solutions  has several warehouses stocked  full of Schedule 5, 10, 40 Pipe to Tube Fittings to fill your needs or job requirements and has the availability to have the "unusual" parts such as fractional sizes, pipe size end caps, Schedule 40 Pipe to Tube ferrules, or Schedule 40 Weld Adapters to Tube O.D. Weld Adapters made and shipped to your location in the time necessary to fill your job requirements. Our domestic fabricator either stocks or will make your size, alloy, length and other instructions needed for  Schedule 5-10-40 Pipe to Tube Fittings so the parts will be correct upon shipment.

NOTE: We have added 1.5", 2", 3", 4", 6" sizes of the Schedule 5 Male and Female I-Line Ferrules and Clamps to our inventory!

Call us at 1-888-909-3569 or 1-855-640-7871.

Ordering Specifications-- Quantity-- Part Number-- Size -- Alloy--